Puppy error #17511 (XL)

Menu
Relevant for:
Last updated a year ago
This article is also available in following languages: 

What happened?

On the Original Prusa XL, communication with the peripheral boards (e.g. Dwarf board) is achieved using the MODBUS protocol. In MODBUS, there are two types of devices: the master and the slave, also known, respectively, as client and server. On Original Prusa XL firmware, the master is the XLBuddy, and each slave is called puppy

Each puppy is assigned a unique address that is used by the XLBuddy. In case of an error in this procedure, the printer will show the message: "Address assignment error".

Error name: Puppy addr assign err

Error code: #17511

The error indicates most likely a configuration problem that might have stemmed from firmware. 

How to fix it?

Download the firmware and if necessary the bootloader compatible with your printer version, and transfer the files to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

Are you still having issues? Contact our support team and let them know that you have tried to fix the issue with these instructions. We will take it from there.
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us