EN
  • Čeština
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

ESP not connected #17533 (XL)

Menu
Relevant for:
XL
Last updated 7 months ago
This article is also available in following languages: 
CSPLDEITFR

What happened?

The Original Prusa XL is equipped with an ESP Wi-Fi module. This module is part of the XLBuddy board. In case the printer cannot find the ESP module, this error will appear.

Error name: ESP not connected

Error code: #17533

How to fix it?

Re-flash firmware

Download the firmware, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

The printer will let you know when the flashing is done. 

A visual inspection

Before accessing any electronic board, ensure that the printer is cold, switched off, and disconnected from the mains for at least 10 minutes. 

In case re-flashing firmware did not solve the issue, access the XLBuddy board for an inspection with the following steps. 

From the rear of the printer, loosen the indicated four screws. It is not necessary to remove them completely. Then, slide up the electronics cover to remove it. This will expose the XLBuddy board, and if present, the XL-Splitter. 

The single-head and dual-head versions of the Original Prusa XL are not equipped with the XL-Splitter board. 

Inspect the boards, in particular the XLBuddy. Check for defects or damage on the surface, such as a detached component, or a visibly burnt spot, especially close to or on the ESP board. 

If needed, disconnect the antenna cable from the XLBuddy board, and extract the XLBuddy board, using the two lower ejectors. Touch any electronic board only from its edges to avoid damaging its components. 

Contact our Technical Support, and let them know you performed these checks, with some pictures from the XLBuddy board, especially if you find anything irregular on its surface. We'll take it from here. 
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us