No FW on USB flash drive #17604 (XL)

Relevant for:
Last updated 11 days ago
This article is also available in following languages: 

What happened?

When flashing the firmware, you might get the message "Firmware file missing in the USB flash!".

Error name: No FW on USB flash drive

Error code: #17604

This error happens when you attempt flashing firmware on the Original Prusa XL, but the printer does not find any firmware in the USB drive that can be uploaded to the printer.

How to fix it?

Download the firmware and if necessary the bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

If the issue persists, the problem might be in the USB flash drive. Find any other USB drive in your household, make sure it is formatted to FAT32, copy both firmware files and repeat the previously described procedure.

Are you still having issues? Contact our support team and let them know that you tried to fix the issue with these instructions. We will take it from there.
Was this article helpful?

Comments

0
Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us