EN
  • Čeština
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Puppy error #17515 (XL)

Menu
Relevant for:
Last updated 6 months ago
This article is also available in following languages: 
CSPLDEITFR

What happened?

On the Original Prusa XL, communication with the peripheral boards (e.g. Dwarf board) is achieved using the MODBUS protocol. In MODBUS, there are two types of devices: the master and the slave, also known, respectively, as client and server. On Original Prusa XL firmware, the master is the XLBuddy, and each slave is called puppy.

XLBuddy firmware includes all the needed files for XLBuddy and puppies, including bootloaders. In case an incompatible bootloader is flashed, the printer will show the message: "Puppy uses incompatible bootloader protocol #, Buddy FW requires #".

Error name: Puppy incompatible bootloader

Error code: #17515

The error message will include the bootloader version that is flashed, and the bootloader number that should be installed. 

How to fix it?

Download the firmware, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

Are you still having issues? Contact our support team and let them know that you tried to fix the issue with these instructions. We will take it from there.
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us