Trinamic drivers on the EINSY board can detect skipped steps and layer shifting. It works only in the Normal mode (not in the Stealth mode). The thresholds for crash detection are set for higher speeds because layer shifting usually happens when the extruder moves quickly between objects and hits a piece of a curled up print.
Crash detection does not work
When you find out that the crash detection does not work, it is most likely going to be a hardware problem within the printer, which is quite easy to fix. Simply follow these instructions:
- Make sure that the printer is running in the Normal mode. The current mode can be checked in the LCD Menu - Settings - Mode [Stealth/ Normal].
- Make sure that your printer's belts and pulleys are properly tightened. Otherwise, the belts can jump over the pulleys or the pulleys can spin around the motor shaft. These issues can prevent the printer from identifying crashes correctly.
Do not hesitate to contact us at email@example.com if you have any further questions.