EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- 日本語
- Home
- About your printer
- Printer features
- One-click print
One-click print
Menu
- Printer description
- Printer features
- Brightness adjustment (SL1)
- Buddy firmware-specific G-code commands
- Crash detection
- Crash dump
- Creating a resin calibration object (SL1/SL1S)
- Dump memory (MK3/S/+ and MK2.5/S)
- Experimental menu (MINI/MINI+)
- Experimental menu (MK3/S/+)
- Filament sensor (MK4, MK3.9)
- Filament sensor MK3 (non-S)
- Flexible steel sheets (guidepost)
- HW setup (MINI/MINI+)
- HW setup (MK2.5/S & MK3/S/+)
- Internet connection (SL1/SL1S)
- IR Filament Sensor (MK2.5S, MK3S)
- IR Filament sensor detection (MK3S)
- LCD brightness adjustment (MK3S)
- LCD screen contrast adjustment (i3)
- Loadcell (XL, MK4)
- Menu structure (SL1/SL1S)
- MMU2S and soluble materials (PVA/BVOH)
- Noisy filament sensor (MINI)
- One-click print
- Pouring resin and starting print
- Power Panic
- Power-modes
- Print Profile (SL1/SL1S)
- Print statistics
- Printer statistics and system information (SL1/SL1S)
- Pronterface and USB cable
- Prusa firmware-specific G-code commands
- Resin Calibration (SL1/SL1S)
- Resin Tank Cleaning (SL1/SL1S)
- Satin steel sheet
- SD card sorting
- Smooth Steel Sheet
- Sound mode (MINI/MINI+)
- Special PA Nylon steel sheet
- SpoolJoin (MMU2S)
- Steel sheet profiles
- Support menu (MK3/S/+)
- Textured steel sheet
- Thermal model calibration
- Top-bar Notifications (SL1/SL1S)
- Tune Menu
- General Information
This article is also available in following languages: 
Both the Original Prusa MINI+ and the SL1 offers a user-friendly feature where the printer automatically displays the project ready for immediate print if:
- The USB flash drive with the project was inserted.
- The project was successfully uploaded from PrusaSlicer or Prusa Connect Local (SL1 only)
It will show you a thumbnail picture and other information regarding your print, like duration and settings.
 |  |
The G-code must be sliced by the latest version of PrusaSlicer, so older G-codes might not have this functionality. To fix that, just slice the model in the latest version of PrusaSlicer.
Was this article helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.