English
Login
3D printers
Materials
Parts & Accessories
Software
3D Models
Applications
Community
Help
Academy
Blog
Company
Support
Original Prusa MINI
Printer maintenance
How to update firmware (MINI/MINI+) | Begin assembly
1. Begin assembly
Step 1 of 10 (Chapter 7 of 23)
Fullscreen mode
Contents
Comments
Available languages
Begin assembly
Contents
Printer maintenance
How to replace a M.I.N.D.A. sensor (MINI)
How to replace a print fan (MINI)
How to replace a hotend PTFE tube (MINI/MINI+)
How to replace a heatsink (MINI/MINI+)
How to replace a Buddy control board (MINI)
How to access and clean the extruder-pulley (MINI/MINI+)
How to update firmware (MINI/MINI+)
Begin assembly
Introduction
Downloading the new firmware
Copying the new firmware
Flashing the new firmware
Flashing the new firmware
Downloading an old firmware
Copying the older firmware
Flashing the old firmware
Flashing the old firmware
How to replace a print head PTFE tube (MINI/MINI+)
Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
How to replace a heatbed (MINI/MINI+)
How to replace an extruder motor (MINI/MINI+)
How to replace SuperPINDA (MINI/MINI+)
How to replace bearings on the X-axis (MINI/MINI+)
How to replace bearings on the Y-axis (MINI/MINI+)
How to replace a heatbed set (MINI/MINI+)
How to replace a heatbed thermistor (MINI/MINI+)
How to replace a hotend thermistor (MINI/MINI+)
How to replace a hotend fan (MINI)
How to replace a hotend heater (MINI/MINI+)
How to replace a heaterblock/heatbreak (MINI/MINI+)
How to post-process the printed parts
How to trim PTFE tube - Original Prusa printers
Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in
to post a comment
Vincent Edwards
•
about 1 year ago
Tip-
If you have firmware older than 4.4 you will need to install 4.4.1 BEFORE you can install a newer version.
Reply
ajmarti
•
about 1 month ago
THANK YOU SOOOOO MUCH. Brand new to this...was getting very frustrated.
Reply
