How to replace a M.I.N.D.A. sensor (MINI)
How to replace a print fan (MINI)
How to replace a hotend PTFE tube (MINI/MINI+)
How to replace a hotend fan (MINI)
How to replace a heatsink (MINI/MINI+)
How to replace a heaterblock/heatbreak (MINI/MINI+)
How to replace a Buddy control board (MINI)
How to access and clean the extruder-pulley (MINI/MINI+)
How to update firmware (MINI/MINI+)
How to replace a print head PTFE tube (MINI/MINI+)
How to replace a heatbed thermistor (MINI/MINI+)
How to replace a hotend thermistor (MINI/MINI+)
Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
- Begin assembly
- Introduction
- Preparing the printer
- M.I.N.D.A./SuperPINDA height adjustment
- First layer calibration
How to replace a hotend heater (MINI/MINI+)
How to replace a heatbed (MINI/MINI+)
How to replace an extruder motor (MINI/MINI+)
How to replace SuperPINDA (MINI/MINI+)
How to replace bearings on the X-axis (MINI/MINI+)
How to replace bearings on the Y-axis (MINI/MINI+)
How to replace a heatbed set (MINI/MINI+)
How to post-process the printed parts
How to trim PTFE tube - Original Prusa printers
Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
See here.