English
Login
Prusa Research a.s.
Prusa Research a.s.

1. Begin assembly

Step 1 of 10 (Chapter 9 of 23)
Contents
Comments
How to update firmware (MINI/MINI+)
  • Available languages

    Čeština
    Polski
    Deutsch
    日本語
    Español
    Italiano
    Français

Contents

Printer maintenance

  • How to replace a M.I.N.D.A. sensor (MINI)
  • How to replace a print fan (MINI)
  • How to replace a hotend PTFE tube (MINI/MINI+)
  • How to replace a hotend fan (MINI)
  • How to replace a heatsink (MINI/MINI+)
  • How to replace a heaterblock/heatbreak (MINI/MINI+)
  • How to replace a Buddy control board (MINI)
  • How to access and clean the extruder-pulley (MINI/MINI+)
  • How to update firmware (MINI/MINI+)
    1. Begin assembly
    2. Introduction
    3. Downloading the new firmware
    4. Copying the new firmware
    5. Flashing the new firmware
    6. Flashing the new firmware
    7. Downloading an old firmware
    8. Copying the older firmware
    9. Flashing the old firmware
    10. Flashing the old firmware
  • How to replace a print head PTFE tube (MINI/MINI+)
  • How to replace a heatbed thermistor (MINI/MINI+)
  • How to replace a hotend thermistor (MINI/MINI+)
  • Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
  • How to replace a hotend heater (MINI/MINI+)
  • How to replace a heatbed (MINI/MINI+)
  • How to replace an extruder motor (MINI/MINI+)
  • How to replace SuperPINDA (MINI/MINI+)
  • How to replace bearings on the X-axis (MINI/MINI+)
  • How to replace bearings on the Y-axis (MINI/MINI+)
  • How to replace a heatbed set (MINI/MINI+)
  • How to post-process the printed parts
  • How to trim PTFE tube - Original Prusa printers
  • Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)

Comments

Log in  to post a comment
Vincent Edwards
Tip-
If you have firmware older than 4.4 you will need to install 4.4.1 BEFORE you can install a newer version. 
ajmarti
THANK YOU SOOOOO MUCH.  Brand new to this...was getting very frustrated.