EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Preload failed #10503 (SL1/SL1S)

Menu
Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
CSPLDEESITFR

What happened?

The printer is displaying the message: Image preloader did not finish successfully!

Error name: Preload failed

Error code: #10503

This error shows that the printer was not able to fully load one of the layers in the model.

How to fix it?

This error would cause the print to fail due to a missing or damaged layer. In PrusaSlicer, open the model and check for any failures or missing layers in the Preview. Reslice the model, and try printing it again. You can also try to repair the model using this guide: Corrupted 3D models for printing.

If the error is shown again, try to print the model printer's internal memory.

If the error is repeated multiple times, the A64 board might be damaged.

Was this article helpful?

Comments

Related

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us