EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Expect overheating #10714 (SL1/SL1S)

Menu
Relevant for:
Last updated 9 months ago
This article is also available in following languages: 
CSPLDEESITFR

What happened?

The printer is displaying the message: Incorrect RPM reading of the fan. The print may continue, however, there's a risk of overheating.

Warning name: Expect overheating

Warning code: #10714 

This warning is shown when the RPM of one of the fans is out of range during the print. The warning can be ignored and the print can continue, but if the printer overheats the print will be stopped.

How to fix it?

The SL1 has three fans: the LED cooling fan, the filter fan, and the right blower fan. If the warning appears, please follow maintenance steps for the fan that generated the issue: SL1/SL1S maintenance. When doing that, also check the cable connections of the fan to the mainboard.

If the right blower fan is the one that showed the warning, make sure that the blower gasket is still in place.

Go to the printer menu in LCD menu -> Settings -> Calibration -> Wizard. The printer will run the self-test. In case the fan also fails during the self-test, switch the connection of two of the fans, and see if the warning will be transferred to the new fan. If the error is transferred, the fan that had the warning originally may need to be replaced.

How to replace the part?

How to replace a blower fan (SL1)

How to replace a UV LED fan (SL1S)

How to replace a blower fan (SL1S)

Was this article helpful?

Comments

Related

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us