• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français

Resin sensor error #10307 (SL1/SL1S)

Relevant for:
Last updated a year ago
This article is also available in following languages: 

What happened?

The printer displays the message: The resin sensor was not triggered. Check whether the tank and the platform are properly secured.

Error name: Resin sensor error

Error code: #10307

How to fix it?

Check the following items

  • If the platform is installed and properly secured.
  • That the tank is firmly tightened by the side screws.

If no issues are found in the tank or platform, check the resin sensor cable by opening the bottom cover.




On the side with the electronics boards from the printer, check if the serrated washer is in contact with the surface of the tilt, the cable is not damaged, and the connector is firmly connected to the board.

Was this article helpful?



Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us