The Original Prusa MK4/MK3.9 is equipped with a loadcell, to detect that the nozzle is close enough to the steel sheet for printing, and to avoid damage that would be caused by the nozzle digging into the steel sheet.
The loadcell sets itself a reference, called tare. In case there is an issue during this procedure, the printer will show the message: "Setting the tare failed. Check the loadcell wiring and connection."
Error name: Loadcell Tare Failed
Error code: #13525 (MK4) #21525 (MK3.9)
Access the LoveBoard, locate the loadcell connector and cable, and check for any loose cable, disconnected cable, or visible damage. The loadcell connector is indicated with the orange arrow in the picture below.
Navigate to LCD Menu - Calibration - Diagnostics - Test Loadcell to restart the loadcell calibration.
During the test, you will be asked to tap the nozzle at a specific time, and a progress bar on top of the screen will be filled. If the progress bar is not filled or the printer shows any errors, please contact our customer support.