- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- 1.75 mm
- Belt tension
- Blade
- Bondtech gears
- Bowden tube
- Buddy board
- Cantilever
- Check the cables
- Chimney (IR-sensor-holder-mmu2s)
- Control buttons
- Controller board (MMU2S)
- Curing / solidifying
- Einsy RAMBo board
- Ethernet port
- Extruder (i3)
- Extruder / Extruder motor (Mini)
- Extruder PTFE tube (Bowden-tube)
- F.I.N.D.A. sensor
- FEP foil
- FFF/FDM
- Filament
- Filament buffer
- Filament tip
- Firmware
- Flexible steel sheet
- Heatbed
- Heater block
- Heater cartridge
- Heatsink
- Hollowing
- Hotend
- Hotend fan
- Idler motor
- Idler screw
- Idler tension-screws
- Indicator LEDs
- IR filament-sensor
- Knob
- LCD screen (Mini)
- Lid
- Liquid resin
- Live adjust Z
- M.I.N.D.A. sensor
- Mesh bed leveling
- Micro USB port
- MMU Idler
- Nozzle
- Object / part manipulation panel
- Octoprint
- Olive
- Original Prusa MK2.5S
- P.I.N.D.A. sensor
- Place on Face
- Power Button (SL1)
- Power switch
- Print display
- Print fan
- Print head
- Print platform
- Print speed
- Pulley motor
- Reset button
- SD card
- Selector
- Selector Knob (MINI)
- Selector motor
- Simple, Advanced and Expert mode
- SL1 file (.sl1)
- Spool holder
- SuperPINDA
- Tank
- Thermistor
- Tilt
- Tilt motor
- Tooltips
- Touchscreen Display / Touch screen
- Tower / Z-Axis (SL1)
- Tube fitting
- USB flash drive
- USB port
- USB port (SL1)
- UV LEDs
- Variable layer height
- Wipe-tower (Purge-tower)
- xBuddy board
The "Live adjust Z" is a feature available on all Original Prusa printers based on the FFF technology, designed to further fine-tune (adjust) the distance between the tip of the nozzle and the print surface. By moving the nozzle closer or further away from the print surface, you can control, how much the melted filament is "squished" into the print surface and therefore affect the adhesion.
If the nozzle is too high, the filament won´t stick properly to the surface, if the nozzle is too low, the filament won´t be able to optimally "flow", leading to a potential clog of the nozzle. To learn more about this feature, please see Live adjust Z.
Related articles
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.