Unsupported printer model #17610 (XL)

Este artículo está también disponible en los siguientes idiomas: 

What happened?

While flashing firmware to your Original Prusa XL an error might occur, and the screen will display the following message: "Firmware/printer types do not match. Make sure you have the right firmware file for your printer model".

Error name: Unsupported printer type

Error code: #17610

This error is shown when firmware made for another printer model is flashed on the Original Prusa XL. 

How to fix it?

Go to the Downloads page, and make sure you are selecting the XL firmware. 

Unzip the files, and transfer them to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

If the issue persists, the problem might be in the USB flash drive. Find any other USB drive in your household, make sure it is formatted to FAT32, copy both firmware files and repeat the previously described procedure.