EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Unsupported printer version #12611 (MINI/MINI+)

Menu
Relevant for:
Last updated a year ago
This article is also available in following languages: 
CSPLDEESITFR

What happened?

While flashing firmware to your printer an error might occur, and the screen will display the following message: "Firmware/printer versions do not match! You are trying to flash FW meant for another revision of the Buddy board".

Error name: Unsupported printer version

Error code: #12611

This error is shown if you are trying to flash a version of the firmware that was not meant for the Buddy board.

How to fix it?

The Original Prusa MINI/+ in its factory state only accepts official firmware. In order to flash a custom firmware, you need to break the appendix on the Buddy board. See how to do that here.

Download the firmware and bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and restart it to initiate the flashing procedure. In case the procedure does not start, reboot the printer using the reset button directly next to the knob, and while the printer is booting up, press once the rotating knob (more about this on alternative method).

If the issue persists, the problem might be in the USB flash drive. Find any other USB drive in your household, make sure it is formatted to FAT32, copy both firmware files, and repeat the previously described procedure.

Are you still having issues? Contact our support team and let them know, that you have tried to fix the issue with these instructions. We will take it from there.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us