Deutsch
Login

IR Filament Sensor

Optischer Filamentsensor am Extruder, eingeführt mit dem S-Upgrade für die Original Prusa MK3/S und MMU2S.Beim MK3/S wird er aktiviert, wenn die Stahlkugel den fs-Hebel in den Sensor drückt. Beim MMU2S wird er aktiviert, wenn das Filament die Bondtech-Zahnräder des Extruders auseinander drückt und der Extruder-Rollenhebel in den Sensor gedrückt wird.

Related articles

Failing Z calibration (MK3S/MK2.5S)

Failing Z calibration (MK3S/MK2.5S)

The size of the extruder and the length of travel of the Z-axis is coded into the firmware. Therefore, if the assembly of the extruder, or the firmware for your extruder, is not…

How to replace a heatbreak/heaterblock/heatsink (MK3/MK2.5)

How to replace a heatbreak/heaterblock/heatsink (MK3/MK2.5)

Err: PRINT FAN ERROR

Err: PRINT FAN ERROR

PRINT FAN ERROR error message occurs when the print fan (the one at the front of the extruder) does not receive any RPM (Revolutions per Minute) readings. This can be caused by…

IR Filament sensor detection (MK3S)

IR Filament sensor detection (MK3S)

With filament sensor detection, the printer will be able to recognize if the connection with the sensor was interrupted (e.g. broken wire or disconnected cable) and take appropriate…

9. First flight

9. First flight

8. Preflight check & Calibration

8. Preflight check & Calibration

G-code preparation for MMU2S

G-code preparation for MMU2S