1. Introduction
EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- 日本語
- Home
- Original Prusa i3 MK2 to MK2.5S upgrade
Original Prusa i3 MK2 to MK2.5S upgrade
Guides
Original Prusa i3 MK2 to MK2.5S upgrade
Original Prusa i3 MK2 to MK2.5S upgrade
All articles
Upgrading MK2/S and MK2.5/S to MK2.5S+
This article describes all the components necessary to upgrade your Original Prusa i3 MK2/MK2S/MK2.5/MK2.5S to the latest iteration of the hardware and software available from Prusa Research. For all intents ...
Top Prusa Forum Posts
2 Questions: Why do I have to use always the slow-speed an printing problems with a new FEP-sheet
updated an hour ago: VtuPrint3D e.U.1 46Changing filament type PETG to PLA. Best approach
updated an hour ago: Diem3 94Weird lines/artifacts on prints
updated 43 minutes ago: Diem2 105Print an entire topic thread at once?
updated 13 hours ago: kennd1 442After replacement hotend kit install, squares on screen, cannot factory reset, can't open com port, no response
updated an hour ago: Diem3 443
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.