Relevant for
The search bar on top of this site searches the entire PrusaSlicer documentation as well as assembly guides and related printer hardware troubleshooting guides. If neither has the answer to your problem, you can try several things:
The PrusaSlicer forum is an active community of PrusaSlicer users. You can post your problem there and discuss it with numerous expert users in the community.
If you use Facebook, there are several active groups that are quick to help you with your problem:
Even though the PrusaSlicer team has 7 full-time developers and several active community contributors, going through reported issues and feature requests take a considerable amount of time. Before you report a new issue, please make sure you've exhausted other options.
There is a good chance that the issue is already reported, you can check the list of reported issues here.
Finally, you can create a new issue here.
7 comments
Impossible d'imprimer une lithophanie à partir de prusaslicer ,il ne gére pad les jpg comme cura.
possible ou pas directement ??
sans faire la bidouille de passer par cura et ouvrir avec le lecteur de gcode puis exporter en obj et rouvrir avec prusaslicer .
pourquoi faire simple quand on peut faire compliqué.
bon print à toutes et tous..
Si vous rencontrez des difficultés pour quoi de ce soit, veuillez s'il vous plait contacter notre support technique que ce soit sur notre live chat ou par mail a [email protected].
Initial beginning, I load the machine with filament to the hot end. Then I set the machine up with the print I want. When the machine starts to print it starts its' run by expelling the strip at the head of the sheet. Then the extruder parks to the right side and stays there. The display reads "Reloading Filament" 99% parking, it never recovers.
I have to reset the machine, unload the filament and then choose the print again. Then it works. The difference is that I'm not preloading the hot end.
Previous SW version did not have this issue.
Crash detected.
I have turned it on and off and sometimes it worked.
Did a factory reset. It then worked for one print and is now crashing again. Very frustrating
You adjust the infill density, the number of perimeters and the number of top and bottom layers and see how the estimated weight changes in the slice preview. The infill density is likely the main thing you can significantly lower to reduce weight, without sacrificing print quality.