EN
  • Čeština
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

High flow print head (HT90)

Menu
Relevant for:
Last updated 3 months ago
This article is also available in following languages: 
CSPLDEITFR

The default print head on the Prusa Pro HT90 is a high-flow print head. This allows a high volumetric rate which will let you print faster. The print head also has a fan control that uses a servo motor.

It is also possible to install a High-temperature print head.

You can identify that the high flow print head is installed when it shows a blue stripe.

Nozzle

The high flow print head comes with a Revo High flow nozzle. Note that this nozzle is not resistant to abrasive filaments, as it is made of brass.

If you wish to print with abrasive filaments, use the Revo ObXidian Nozzle.

The nozzle can be changed by screwing and unscrewing by hand, no tools should be used. For that, follow the instructions here: Nozzle replacement (HT90).

  • Recommended cleaning methods:
      • Cleaning filament
      • Warm pull
      • Cold pull
      • Brass brush for the outside
  • Non-recommended cleaning methods:
      • Needle
      • Steel wire brush
      • Blow torch

 

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us