Static memory has been overwritten

Updated 1 month ago ​by Tomáš Chvalina

The error message Static memory has been overwritten should not appear on our official firmware releases as these have already gone through our testing. However, it can appear in self- or community-built firmware versions.

Either way, the cause of this error is rather simple, there is something causing the bootloader to overflow and the firmware won't boot properly.

Troubleshooting

  1. Do a factory reset for all data. A guide on how to do it can be found at Factory reset.
  2. Once you do so, re-flash the newest firmware. A guide on how to do it can be found at Firmware updating and flashing.
  3. After that, you should be able to operate your printer normally.

Do not hesitate to contact us at info@prusa3d.com if you would have any further questions.



How did we do?