EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Broken supports (SL1/SL1S)

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
CSPLESDEITFR

Broken supports (or missing parts of supports) are usually caused by incorrect settings in the PrusaSlicer. The supports are either too thin or the exposure time is set to a value too low. In some cases, this can be also caused by a dirty FEP film.

Try printing one of the sample objects to see whether the issue remains. If the sample object was printed without trouble, reset your PrusaSlicer settings.
 

If the sample object has the same sort of trouble, inspect the FEP film in the resin tank – it may be dirty. In very rare scenarios, a faulty UV LED panel can be the cause.
Was this article helpful?

Comments

Related

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us