EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Scratches/bubbles on prints (SL1/SL1S)

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
CSPLESDEITFR

Bubbles or small scratches (also appearing like cracks) on the object are caused by small pieces of dirt or debris in the tank (vat) you are using. These small objects travel in the tank during printing, creating paths that resemble scratches as they move.

Make sure that the resin is 100% pure and free of small dirt particles. Filter the contaminated resin, for example, through a coffee filter. Also make sure your print tray is 100% clean and there are no dirt particles on the FEP film. Rinse the tank in warm water and then dry it with a paper towel.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us