• English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français

Tower moving failed #10103 (SL1/SL1S)

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 

What happened?

The printer displaying the message: Moving the tower failed. Make sure there is no obstacle in its path and repeat the action.

Error name: Tower moving failed

Error code: #10103

Issued when the printer has attempted to home the tower but has found resistance to move it.

How to fix it?

Make sure that the latest firmware is installed. Check if the three screws indicated in the pictures below are tightened and not moving.

See if there is nothing physically blocking the movement of the tower. In case you cannot find anything blocking it, add a small amount of super lube on the trapezoidal rod.

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us