EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Homing error X #26304 (MK4S) #13304 (MK4) #21304 (MK3.9) #23304 (MK3.5)

Menu
Relevant for:
Last updated 2 months ago
This article is also available in following languages: 
CSPLDEESITFRJA

What happened?

The Original Prusa MK4S/MK4/MK3.9/MK3.5 displays the message: "Failed to home the extruder in X-axis, make sure there is no obstacle on X-axis".

Error name: Homing error X

Error code: #26304 (MK4S) #13304 (MK4) #21304 (MK3.9) #23304 (MK3.5)

The error is most likely caused by a bad movement of the print head along the X-axis. 

How to fix it? 

X-axis movement

Make sure there are no obstructions in the path of the X-axis. For example, there might be a piece of filament stuck around the belt, or on a smooth rod, from a previous print.

X-axis belt tension

Check the X-axis belt tension and adjust it, following our dedicated article on belt adjustment.

X-axis motor pulley

The X-axis motor pulley is attached to the X-axis motor shaft. The motor shaft has one flat side. The pulley has two set screws: ensure that one of the two set screws is aligned with the flat part of the motor shaft. Make sure the other set screw is also tightened, not excessively, and that there is a small space between the pulley and the motor. 

X-carriage assembly

An over-tightened or loose X-carriage and X-carriage-clip assembly might cause the error. If none of the previous steps resolved the issue, refer to our assembly manual to see the assembly of the X-carriage and X-carriage-clip.

xBuddy connection

Check the motor connections on the board. For that, open the four screws that hold the xBuddy box cover. Make sure that the motor connector is not loose, and that the X-axis motor connector has not been accidentally switched with the Y-axis motor or any other motor.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us