Loadcell Tare Error #26524 (MK4S) #13524 (MK4) #21524 (MK3.9)

Relevant for:

MK4 MK3.9 MK4S

Last updated 4 months ago

This article is also available in following languages:

What happened?

The Original Prusa MK4S/MK4/3.9 is equipped with a loadcell, to detect that the nozzle is close enough to the steel sheet for printing, and to avoid damage that would be caused by the nozzle digging into the steel sheet.

The loadcell sets itself a reference, called tare. In case there is an issue right before the start of this procedure, the printer will show the message: "There was an error requesting the tare for loadcell."

Error name: Loadcell Tare Error

Error code: #26524 (MK4S) #13524 (MK4) #21524 (MK3.9)

How to fix it?

Before you start, make sure:

the filament is unloaded from the extruder
the printer is turned OFF and unplugged from electricity
the hotend and the heatbed are cooled down to ambient temperature

Access the LoveBoard, locate the loadcell connector and cable, and check for any loose cable, disconnected cable, or visible damage. The loadcell connector is indicated with the orange arrow in the picture below.

Re-calibrate the loadcell

Do not manipulate or touch the printer unless the instructions on the printer screen prompt you to do so.

Navigate to LCD Menu - Calibration - Diagnostics - Test Loadcell to restart the loadcell calibration.

During the test, you will be asked to tap the nozzle at a specific time, and a progress bar on top of the screen will be filled. If the progress bar is not filled or the printer shows any errors, please contact our customer support.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.