Ventilation grille (on the top): to maintain airflow when printing with materials such as PLA or PETG.
Frame: an exoskeleton design for maximum strength and robustness.
Nextruder: our next-generation extruder with a planetary gearbox and LoadCell sensor.
XY-carriage: a horizontal assembly consisting of motors, belts, linear rails, pulleys, and plastic parts; moves the Nextruder left and right, and forward and backward.
Handle: located on both sides, used for lifting and moving the printer.
PTFE tube: insertion point for filament.
Z-Axis: a vertical assembly consisting of smooth and threaded rods and three motors; moves the heatbed up and down.
Door Handle: used to open the door.
Spool Holder and Filament Spool: the Prusa CORE One L is compatible with 1.75mm filaments.
Print sheet: easy to maintain; held in place with strong magnets embedded in the heatbed.
Heatbed: heated pad with aluminum construction for perfect heat conduction.
LED indicator light: indicates the printer's current status using different colors.
USB port and USB drive: used to print G-Codes (print files) and flash firmware from the USB drive.
LCD: used for control and configuration of the printer.
Rotary knob: the main control device with the reset button directly below it.
Filament Insertion Point: As you insert the filament into the PTFE tube on the side of the printer (next to the spoolholder), this is the point where it feeds into the Nextruder.
Idler lock (swivel): Flip upwards to unlock the idler door.
Idler: Maintains pressure on the filament strand, which is moved further into the extruder by the extruder gear Planetary gearbox, and extruder motor.
Planetary gearbox and extruder motor.
Electronics cover: Covers the break-out board.
Thumbscrews: You can detach the nozzle by unscrewing the thumbscrews.
Print Fan shroud: Directs the air from the high-performance turbine print fan towards the printed object.
Heaterblock with Nozzle: By default, a CHT 0.4 mm nozzle is installed.
Nextruder lever: Automatically opens and closes the ventilation grille.
Idler screws: These screws are used to adjust the pressure of the idler.
Print fan (back side): High-performance turbine for cooling the printed object.
Heatsink fan: Cools the aluminum heatsink behind it.
Was this article helpful?
This action is available only to registered users. Please log-in.
