3rd party accessories & Other projects

All articles

• 

  Octoprint - Configuration and install

  This article covers how to configure your own image for any Raspberry Pi (RPi) from scratch. Following this article, you will have connected a base installation of Octoprint which you ...

• 

  Changing or replacing the nozzle (MK2.5/S, MK3/S/+, MK3.5/S)

  The Original Prusa MK2.5/S, MK3/S/+, and MK3.5/S use the E3D V6 Hotend. Any nozzle that is compatible with the E3D V6 Hotend can be installed on it. The stock nozzle ...

• 

  Different nozzle types

  The Prusa FFF printers are equipped with a brass nozzle. This article will review the main information about the nozzles that can be used with your printer. Brass has excellent heat ...

• 

  PrusaPrint (Rpi Zero and Octoprint)

  Raspberry Pi Zero W has no 5GHz Wi-Fi (only 2.4GHz), and a somewhat weak processor. It does not support using a large amount of Octoprint-plugins or streaming of video and ...

• 

  Changing/replacing the nozzle (MINI)

  This article will guide you through the replacement of the nozzle on your Original Prusa MINI printer. Note that this requires you to have some tools available and also be ...

• 

  Prusa Face Shield disinfection

  ATTENTION: Don't copy/paste the information below, always link to this article. The information is subject to change. About the Prusa Face Shield The 3D-printable face shield is a reaction to the urgent ...

• 

  About Octoprint

  Octoprint is an open-source system for remotely controlling and monitor your printer. Start/stop/pause prints, change printing temperatures and settings while printing, stream video, or captures images during printing. It does ...