Prusa Knowledge Base
EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

All articles

  • Octoprint - Configuration and install

    Octoprint - Configuration and install

    This article covers how to configure your own image for any Raspberry Pi (RPi) from scratch. Following this article, you will have connected a base installation of Octoprint which you ...

  • PrusaPrint (Rpi Zero and Octoprint)

    PrusaPrint (Rpi Zero and Octoprint)

    Raspberry Pi Zero W has no 5GHz Wi-Fi (only 2.4GHz), and a somewhat weak processor. It does not support using a large amount of Octoprint-plugins or streaming of video and ...

  • About Octoprint

    About Octoprint

    Octoprint is an open-source system for remotely controlling and monitor your printer. Start/stop/pause prints, change printing temperatures and settings while printing, stream video, or captures images during printing. It does ...

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to info@prusa3d.com or through the button below.