EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

xBuddy and LoveBoard electronics wiring (MK4/S, MK3.9/S)

Relevant for:
Last updated 25 days ago
This article is also available in following languages: 
CSPLDEESITFRJA

The Original Prusa MK4/S and MK3.9/S are equipped with two proprietary boards: the xBuddy and the LoveBoard. The two are connected by a main cable. When replacing a part in the extruder, you will be able to do so directly on the extruder, without needing to open the extruder cable bundle or the main board.

Each connector has a label near it showing the component attached there.

LoveBoard

This connector breakout board connects all the extruder cables. In order to access the LoveBoard, slide up the cover, and unscrew the love board cover right.

xBuddy board

The xBuddy is a 32-bit board, with Trinamic drivers for silent motor operation and Wi-Fi/LAN connection.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us