EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

PrusA64 mainboard electronics wiring (SL1)

Relevant for:
Last updated 2 years ago
This article is also available in following languages: 
CSDEESFRITPL

With the technology used in MSLA 3D printing, the Original Prusa SL1 has a different mainboard arrangement compared to our FFF printers. It uses two boards instead of one:

  • PrusA64 mainboard with A64 ARM CPU and graphics driver for both screens
  • Motion controller board (MC) with drivers controlling all movements (tilt and tower)

Electronics wiring

For the exact order of the wiring and cable management, we recommend seeing the electronics section of the assembly manual.

If you are replacing the PrusA64 board, please see our guide How to replace the A64 board (SL1).
Was this article helpful?
This action is available only to registered users. Please log-in.

Comments

Please sign in before adding a comment.
0
Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to info@prusa3d.com or through the button below.