JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login
Relevant for:
Last updated 2 years ago
This article is also available in following languages: 
ENCSPLESDEITFR

Large holes (defects) in printed objects are almost exclusively caused by dirt on the FEP foil or loose particles in the resin. Tiny pieces of debris on the bottom of the tank will block the light from reaching the resin correctly. Dirt particles also have a tendency to grow during the print, which will increase the size of the hole through the course of the print.

Make sure the FEP foil on the bottom of the tank is perfectly clean. Empty the tank of resin, filtering it with the sieve to make sure any hard particles are not poured back into its bottle. Carefully remove any dirt / solidified bits.

If the FEP foil is cloudy, use hot water and dishwashing soap to clean and restore the original look. The FEP film is rated for 10 prints, but will most often last you longer than that.

If you need to replace the FEP film, the printer comes with spares and it can also be found in our eshop for the SL1 and for the SL1S. Follow our guide on replacing it.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us