English
Čeština
Español
Italiano
Deutsch
Polski
Français

Scratches/bubbles on prints (SL1/SL1S)

Relevant for:

SL1 SL1S

Last updated 3 years ago

This article is also available in following languages:

Bubbles or small scratches (also appearing like cracks) on the object are caused by small pieces of dirt or debris in the tank (vat) you are using. These small objects travel in the tank during printing, creating paths that resemble scratches as they move.

Make sure that the resin is 100% pure and free of small dirt particles. Filter the contaminated resin, for example, through a coffee filter. Also make sure your print tray is 100% clean and there are no dirt particles on the FEP film. Rinse the tank in warm water and then dry it with a paper towel.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.