JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login
Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
ENCSPLESDEITFR

Even though SLA printers can achieve much better resolution than standard FFF/FDM 3D printers, layers on objects can be still visible if you look very closely. If you feel like the layers on your prints are too visible, there’s a couple of things you can try.

Print a sample object with a good/tested resin (like the sample bottle of Prusa Orange) and see if the issue is still present. If it’s not, then the cause is usually related to slicing settings.

 

Possible solutions

  • Try rotating the object to eliminate gradually rising/declining surfaces.
  • Extreme exposure times can also produce visible layers.
  • Mixed / low-quality resins can also affect the print quality – use a fresh, high-quality resin and shake the bottle for at least 20 seconds before you pour the resin in the tank.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us