EN
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

How replace the CoreXY Cover Rear (Original Prusa XL)

Menu

How replace the CoreXY Cover Rear (Original Prusa XL)

How replace the CoreXY Cover Rear (Original Prusa XL)
Relevant for:
XL
Last updated a year ago
How replace the CoreXY Cover Rear (Original Prusa XL)
 Difficulty
Easy
 Steps
8
 Available languages
PLDEITFR

Step 1 Introduction

Introduction
Introduction
Introduction
⬢This guide will take you through the replacement of the CoreXY Cover on the Original Prusa XL.
The following instructions are compatible with all Original Prusa XL.
⬢Check out the images and descriptions to identify which version your printer has:
⬢OLD XY Core cover: a full metal sheet with five holes on its bottom edge. If you have this version of the part, follow the instructions in the manual.
⬢NEW XY Core cover: metal sheet with a perforated pattern of hexagonal holes. If your printer has this version, you already have the latest version and there is no need to continue with the guide.
⬢All necessary parts are available in our eshop prusa3d.com.
Note that you have to be logged in to have access to the spare parts section.
Do not throw away any of the removed fasteners. You will need them again.

Step 4 Back cover disassembly

Back cover disassembly
Back cover disassembly
Back cover disassembly
Back cover disassembly
⬢Using a T10 Torx key, loosen four M3x8bT screws.
⬢Using a T10 Torx key, loosen two M3x8bT screws from the upper side of the cover.
⬢Unplug the PE cable from the cover.

Step 5 Core XY cover detaching

Core XY cover detaching
Core XY cover detaching
Caution: The sheet metal part's edges may be sharp, so handle with care.
⬢Using both hands, carefully remove the CoreXY cover from the printer.

Step 6 Attaching the CoreXY cover

Attaching the CoreXY cover
Attaching the CoreXY cover
Attaching the CoreXY cover
Attaching the CoreXY cover
⬢Using both hands, attach the new CoreXY cover.
The CoreXY cover must fit under the side metal sheets on both sides.
⬢Locate the PE cable near the right CoreXY motor (from the back of the printer).
⬢Connect the PE cable all the way to the faston.

Step 7 New CoreXY cover securing

New CoreXY cover securing
New CoreXY cover securing
New CoreXY cover securing
⬢Using the T10 Torx key, tighten four M3x8bT screws to secure the cover.
⬢From the upper side of the CoreXY cover, tighten two M3x8bT screws.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us