1. Begin assembly

Printer maintenance

• How to replace the filament sensor (HT90)
• Unpacking the printer (HT90)
• How to install the Camera dummy module (HT90)
• How to replace the door (HT90)
• How to lubricate linear bearing rails (HT90)
• How to replace HEPA filter (HT90)
• How to clean external filters (HT90)
• How to replace the desiccant in the Prusa Pro Filament Drybox
• How to replace a high-temperature nozzle (HT90)
• How to assemble the spool holder (HT90)
• How to replace external input fuse (HT90)
• How to replace the LCD control panel (HT90)
• How to replace the PTFE Bowden tube (HT90)
  1. Begin assembly
  2. Introduction
  3. Tools necessary for this guide
  4. Protecting the print area
  5. Disconnecting the PTFE tube
  6. Removing the PTFE Bowden tube
  7. New PTFE Bowden tube: parts preparation
  8. Inserting the new PTFE Bowden tube
  9. Guiding the PTFE Bowden tube
  10. Securing the PTFE tube
  11. Attaching the magnetic end
  12. All done
• How to lubricate the magballs (HT90)