1. Begin assembly

Printer maintenance

• How to replace the CoreXY plastic parts
• How to install the Nextruder V6 Nozzle Adapter (XL single-tool)
• How to replace the Prusa Nozzle (XL single-tool)
• How to replace the Hotend assembly (XL single-tool)
• Packing printer for transport - Original Packing Material (XL)
• How to replace the Prusa Nozzle (XL multi-tool)
• How to replace a Z-axis motor (XL)
• Packing the XL Multi-tool for return - Original Packing material
• How to replace a heatbed tile and a heatbed tile cable (XL)
• How to replace a print fan (XL single tool)
• How to fix Modular bed error (HW solution)
• How to replace trapezoid nuts (XL)
• How to clean the side filament sensor (XL)
• How to change xLCD and xLCD cable (XL single-tool)
• How to replace a Dwarf board (XL multi-tool)
• How to replace Nextruder heatsink (XL Multi-tool)
• How to replace a Dwarf board (XL single-tool)
• How to replace the Hotend assembly (XL multi-tool)
• How to replace a hotend thermistor (XL Single-Tool)
• How to replace a Z-axis linear rail (XL)
• How to replace a profile insert (XL)
• How to replace the hotend fan (XL Multi-tool)
• How to replace a PSU (XL)
• How to replace a hotend heater (XL Single-Tool)
• How to lubricate the coupler pins on Original Prusa XL (Multi-Tool)
• How to replace the tch-profile-insert (XL)
• How to replace the Sandwich Board (XL)
• How to replace the rubber band on Original Prusa XL (Multi-tool)
• How replace the CoreXY Cover Rear (Original Prusa XL)
• How to install the Nextruder V6 Nozzle Adapter (XL Multi-Tool)
• How to replace a XY motor (XL)
• Packing the XL Enclosure for return - Original Packing material
• How to change the belt (XL)
• How to replace the main cable connector cover (XL)
• How to replace the PDU splitter (XL)
  1. Begin assembly
  2. Introduction
  3. Necessary tools
  4. Printer preparation
  5. Removing the middle-rear panel
  6. Disassembling the switch cover
  7. Removing the PSU cover
  8. Removing PSU cables (left)
  9. Removing PSU cables (middle)
  10. Removing PSU cables (right)
  11. Removing PSU from frame
  12. Removing the PDU splitter
  13. The new PDU splitter: parts preparation
  14. Attaching the new PDU splitter
  15. Re-attaching the main PSU - part 3
  16. Re-attaching the middle PSU
  17. Re-attaching the right PSU
  18. Assembling the switch covers
  19. Assembling the PSU cover
  20. Assembling the middle-rear panel
  21. Testing the printer
  22. Good job!
• How to replace the print fan (XL multi-tool)
• How to replace trapezoid nuts (XL)
• How to lubricate linear bearing rails (XL)
• How to change the xLCD (XL)
• How to set up a Buddy3D Cam
• How to replace Nextruder heatsink (XL Single-tool)
• How to replace a Nextruder (XL single-tool)