1. Begin assembly

Printer maintenance

• How to replace Heatbed (CORE One)
• How to replace Heatbed Thermistor (CORE One)
• Buddy3D Camera for CORE One Installation
• How to replace the Prusa Nozzle (CORE One)
• How to reverse the door orientation (CORE One)
• How to pack the Prusa CORE One for return - Original Packing material
• How to install Advanced Filtration (CORE One)
• How to pack the Prusa CORE One for return - Custom Packing material
• How to replace the xBuddy board (CORE One)
• How to replace Nextruder Filament Sensor (CORE One)
• How to replace Heatsink NTC Thermistor (CORE One)
• How to replace Hotend Heatsink (CORE One)
• How to replace the print fan (CORE One)
• How to replace the Heatbed Power Cables (CORE One)
• How to replace a Hotend Heater (CORE One)
  1. Begin assembly
  2. Introduction
  3. Tools necessary for this guide
  4. Printer Preparation (Part 1)
  5. Printer Preparation (Part 2)
  6. Top Cover Removal
  7. Heatbed Protection
  8. Nextruder Uncovering
  9. Cables Disconnecting
  10. Hotend Assembly Removal
  11. Silicone Sock Removal
  12. Heater Removal
  13. Heater Preparation
  14. Heater Assembly
  15. Hotend Insertion
  16. Nozzle Insertion Check
  17. Hotend Cables Guidance
  18. Cables Connection
  19. Nextruder Cover
  20. Top Cover
  21. Turning the Printer On
  22. Nozzle Set Up
  23. Final check
• How to replace a hotend assembly (CORE One)
• How to install the Nextruder V6 Nozzle Adapter (CORE One)
• How to replace the door sensor (CORE One)
• How to replace the side filament sensor (CORE One)