English

1. Tools necessary for this chapter

Step 1 of 42 (Chapter 6 of 9)

Contents

Comments

⬢For the following steps, please prepare:

⬢2.5mm Allen key

⬢Needle-nose pliers for tightening and cutting zip ties

⬢Torx key T8/10

⬢Phillips screwdriver

Original Prusa MK4 kit assembly

1. Introduction
2. Frame assembly
3. X-axis & X-carriage assembly
4. Z-axis assembly
5. Nextruder assembly
6. xLCD assembly
7. Y-carriage & Heatbed assembly
8. Preflight check
Manual changelog MK4 kit

Comments

Nirole

•

No one has mentioned an arrow on the underside of the knob. Could that help align the orientation of the knob?

Didier

•

At that point it would be fair to inform those of the users who, after the printer assembly, will continu with the enclosure assembly, that most of the following steps WILL HAVE TO BE UNDONE to integrate the printer into the enclosure! This includs also the attatchment of the power unit to the printer frame.If you are in this case I strongly recommand to read the printer preparation steps described in 'Original Prusa Enclosure Assembly', starting at '2c. Preparing the printer (MK4)'.

Shane

•

it is generally point to the tool itself not the individual end, it is the same for the 2.5 allen key.

Bob Johnson

•

Tools necessary picture has the arrow points to the T8 end of the key but the screws are T10