JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Filament tip

Before inserting the filament into the machine, always cut the tip. There are two ways you can do that:

  • Cut the filament at a 45° angle
  • Grab the filament about 10 cm from its end and twist it in a circular motion until it breaks off

The second method is preferable for the Original Prusa MMU2S. 

If the filament tip has a blob/head on the end from the previous print, it can cause issues when loading the filament.

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us