1. Begin assembly

Printer maintenance

• How to use Prusament Refill 900g
• How to replace the filament sensor (HT90)
• Unpacking the printer (HT90)
• How to install the Camera dummy module (HT90)
  1. Begin assembly
  2. Introduction
  3. Tools necessary for this chapter
  4. Preparing the printer
  5. Door opening stopper releasing
  6. Door opening stopper removing
  7. Lid opening
  8. Camera module removing
  9. Camera dummy module: parts preparation
  10. Camera dummy module installing
  11. Camera dummy module securing
  12. Lid closing
  13. Door opening stopper securing
  14. Printer connecting
  15. Well done!
• How to replace the door (HT90)
• How to lubricate linear bearing rails (HT90)
• How to replace HEPA filter (HT90)
• How to clean external filters (HT90)
• How to replace the desiccant in the Prusa Pro Filament Drybox
• How to replace a high-temperature nozzle (HT90)
• How to tension the belts (HT90)
• How to assemble the spool holder (HT90)
• How to replace external input fuse (HT90)
• How to replace the LCD control panel (HT90)
• How to replace the PTFE Bowden tube (HT90)
• How to lubricate the magballs (HT90)