1. Belt tensioning
Step 1 of 18 (Chapter 12 of 12)
Contents
Comments
This chapter will guide you through calibrating and preparing the printer for its first run. Starting with tensioning the belts:
⬢The left screw adjusts the upper belt.
⬢The right screw adjusts the lower belt.
⬢Double-check that the M3x30 screws in the belt tensioners were lubricated during assembly.
WARNING: Incorrect procedure may result in damage to plastic parts or seizing of screws. Before adjusting the belt tension, read the dedicated article:
Do not forget to come back here after adjusting the belts.
Contents
Prusa CORE One+ (Gen 2) conversion kit (1.00)
- 1A. Introduction
- 1B. MK4S Inspection
- 1C. Printer Dissasembly
- 1D. Component Prep
- 2. Base assembly
- 3. Back assembly
- 4. Heatbed assembly
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- 8. Trim, Door & xLCD
- 9. Calibration & First run
- Belt tensioning
- Installing the spoolholder: Parts preparation
- Attaching the print sheet and spoolholder
- Firmware update
- Turning on the printer
- Setting up the printer: Intro
- Setting up the printer: Network setup
- Wizard: Intro
- Wizard: Door Sensor Calibration
- Wizard: Loadcell Test
- Wizard: Gearbox Alignment
- Wizard: Filament Sensor Calibration
- Wizard complete
- Haribo time
- Handbook
- Give us feedback
- Prusa knowledge base
- Join Printables!
Comments
Log in to post a comment
No comments