English
Login
3D printers
Materials
Parts & Accessories
For Business
Software
3D Models
Community
Help
Courses
Blog
Company
Support
Prusa CORE One
Prusa CORE One (assembled) (1.01)
2. Unpacking the printer | Preparing the package
1. Preparing the package
Step 1 of 8 (Chapter 2 of 5)
Contents
Comments
CAUTION: The package is heavy—handle it with care!
The package fixations and foam inserts may vary.
⬢
Open the package. On the top layer, you will find:
⬢
Print sheet
⬢
USB drive
⬢
Power cord
⬢
Anti-vibration bars
⬢
Remove these items from the package and place them in a safe spot for later use.
⬢
Remove the cardboard protection layer.
⬢
Take out the Prusament cardboard box and set it aside.
Loading...
Next
Contents
Prusa CORE One (assembled)
1. Introduction
2. Unpacking the printer
Preparing the package
Removing the box
Removing the cardboard layer
Anti-vibration feet: parts preparation
Sticking the anti-vibration bar
Sticking the anti-vibration feet
Removing the inside protections
Preparing the Tool pack
3. Mounting the xLCD
4. Calibration & First run
Manual changelog
Comments
Log in
to post a comment
Mike
•
FYI - anti-vibration bars are only included up until May 2025. This is mentioned in one of the next couple steps...just in case anyone else starts tearing the house apart looking for them.
Reply
bzhmaddog
•
Found the USB key loose at the bottom of the package. A small piece of double sided tape would handle that nice
Reply
James
•
In Step #1, picture #2 -- the bullet point colors for the USB drive and the Power Cord are swapped.
Reply
