English
Login
Prusa Research a.s.
Prusa Research a.s.

1. xBuddy Prep

Step 1 of 26 (Chapter 4 of 13)
Contents
Comments
โฌขThere might be thermal pads stuck to the rear of the xBuddy board. Remove the thermal pads and clean up any glue residue.
Do not use sharp object to remove the pads.

Contents

Prusa CORE One+ conversion kit (1.02)

Comments

Log inย  to post a comment
Error
โ€ข
Like brimfielda said. there are small pads which can be used to remove it.
Alcohol cleans the pads after removal.
Reply
OctoPrints 3D
โ€ข
the only problem one for me was the big pad. it dissolved as i was removing it so it was a bit of a pain. a small plastic spudger worked wonders for removing it
Reply
brimfielda
โ€ข
There's a film on the bottom holding it on. I could get it off with a fingernail once the bulk was off.
Reply
Lord_Mike
โ€ข
I used a 3d printer plastic scraper to remove the thermal pads safely and cleaned area with alcohol pads.
Reply