⬢Some parts of your printer can be reused for upgrading, so it’s essential to check their condition before starting.
This chapter will guide you through a visual inspection of these parts. If you find any in poor condition, you’ll have enough time to order replacements while still using the printer.
Do not disassemble or disconnect anything until prompted.
⬢Any parts that are found to be in poor condition during the inspection can be replaced with new parts. Everything is available in our eshop.
Please note that you have to be logged in to access all parts.
What happens with all the miscellaneous hardware removed during the disassembly process? I had a TON of 3mm hex-head screws left over when I got to the first assembly stage (installation of the heatbed thermistor). If they aren't going to be re-used, then this should be stated up front so users can put them back into their general hardware cache and not worry (as I did) about making sure I captured every screw and nut.
