⬢Universal screwdriver

⬢4.0 mm Flathead screwdriver bit

⬢2.0 mm Hex screwdriver bit

⬢A piece of cloth for use as a heatbed protection during the assembly. Hint: use the dust cloth.

⬢Before you proceed, it is recommended to protect the heatbed.

⬢Make sure the heatbed is cooled down to ambient temperature. Place the dust cloth approximately to the front center part of the heatbed.

⬢Turn the power switch OFF (symbol "O").

⬢Unplug the power cord from the right side of the printer by pressing the safety latch.

⬢Open the lid.

⬢Using a flat screwdriver, loosen the Door-opening-stopper by turning it 120° counter-clockwise.

⬢Continúa en el siguiente paso.

⬢Remove the Door-opening-stopper by pushing from the inside of the printer.

⬢Repeat the process on the second Door-opening-stopper on the other side of the lid.

From now on, we will demonstrate the Camera dummy module replacing on the printer without the lid for better visibility. Please note, do not remove the lid from your printer. The printer in the pictures will be shown without the lid for improved visualization for the customers.

⬢Using a 2 mm Allen bit, remove two M3x8b screws from the Camera-module.

⬢Gently pull out the Camera-module from the panel.

⬢Gently pull out the black safety latch to release the Camera module cable.

⬢Leave the Camera module cable hanging for now.

⬢Gently slide the Camera module cable facing with a blue strip towards you to the Camera-dummy-module.

⬢Align the Camera module cable with the Camera-dummy-module

⬢Continúa en el siguiente paso.

⬢Gently insert the Camera-dummy-module into the panel.

⬢Secure the Camera-dummy-module with two M3x8b.

⬢Good job! The module is installed.

⬢Now slowly pull the lid downwards until the plastic cut-outs for the Door-opening-stopper are under the top panel. See the picture.

⬢Using a flat screwdriver, secure the Door-opening-stopper by turning it clockwise.

⬢Repeat this proces on the left side of the lid.

⬢Close the lid

⬢Remove the dust cloth from the bottom.

⬢Plug the power cord from on the right side of the printer.

⬢Enciende el interruptor (símbolo "I").