How to install the Camera dummy module (HT90)

Relevant for:

HT90

Last updated 5 months ago

Difficulty

Easy

Steps

Available languages

Step 1 Introduction

⬢This guide will take you through the installation of the Camera-dummy-module on the HT90.

組み立てを始める前に、部品をプリントしてください。

⬢The Camera-dummy-module is available is at Printables.com.

Recommended material is PA11CF (for stiffness and durability due to high temperatures in the chamber)

Step 2 Tools necessary for this chapter

⬢For this chapter, please prepare:

⬢Universal screwdriver

Don't have any ? Visit our e-shop Prusa3D.com

⬢4.0 mm Flathead screwdriver bit

⬢2.0 mm Hex screwdriver bit

⬢A piece of cloth for use as a heatbed protection during the assembly. Hint: use the dust cloth.

Step 3 Preparing the printer

⬢Before you proceed, it is recommended to protect the heatbed.

⬢Make sure the heatbed is cooled down to ambient temperature. Place the dust cloth approximately to the front center part of the heatbed.

⬢Turn the power switch OFF (symbol "O").

⬢Unplug the power cord from the right side of the printer by pressing the safety latch.

Step 4 Door opening stopper releasing

⬢Open the lid.

⬢Using a flat screwdriver, loosen the Door-opening-stopper by turning it 120° counter-clockwise.

The Door-opening-stopper is a printer part, just a slight twist will loosen this part.

⬢Proceed to the next step.

Step 5 Door opening stopper removing

⬢Remove the Door-opening-stopper by pushing from the inside of the printer.

⬢Repeat the process on the second Door-opening-stopper on the other side of the lid.

Step 6 Lid opening

⬢Now slowly pull the lid up to the second step.

From now on, we will demonstrate the Camera dummy module replacing on the printer without the lid for better visibility. Please note, do not remove the lid from your printer. The printer in the pictures will be shown without the lid for improved visualization for the customers.

⬢Using a 2 mm Allen bit, remove two M3x8b screws from the Camera-module.

⬢Gently pull out the Camera-module from the panel.

⬢Gently pull out the black safety latch to release the Camera module cable.

⬢Leave the Camera module cable hanging for now.