JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

How to update PrusaLink (MK2.5/S MK3/S/+)

Menu

How to update PrusaLink (MK2.5/S MK3/S/+)

How to update PrusaLink (MK2.5/S MK3/S/+)
Last updated 8 months ago
How to update PrusaLink (MK2.5/S MK3/S/+)
 Difficulty
Easy
 Steps
5
 Available languages
ENCSPLDEESITFR

Step 2 Version compatibility

Version compatibility
Version compatibility
Version compatibility
Version compatibility
⬢

OTA updates require PrusaLink version 0.7 or newer running on your RPi 3 / 4 connected over USB, or RPi Zero connected via GPIO.

You can easily check the version in the Settings tab in PrusaLink or in Prusa Connect.
⬢

If you are running PrusaLink version 0.7RC3 or older,

You have to manually flash a newer PrusaLink image onto the SD card using Raspberry Pi imager; essentially making a fresh PrusaLink installation.

This way, you can also update PrusaLink setup with no internet access.

Step 3 OTA PrusaLink Update (in PrusaLink)

OTA PrusaLink Update (in PrusaLink)
OTA PrusaLink Update (in PrusaLink)
OTA PrusaLink Update (in PrusaLink)
OTA PrusaLink Update (in PrusaLink)
⬢Open up PrusaLink, log in and visit the Settings tab.
⬢Click Check Updates.
Note that this function works only on a network with an internet access.
⬢If there are any updates available, click the Upgrade button.
⬢Confirm upgrading.

Step 4 Update complete (in PrusaLink)

Update complete (in PrusaLink)
Update complete (in PrusaLink)
Update complete (in PrusaLink)
Update complete (in PrusaLink)
⬢Wait until the update is complete. This might take up to a minute or two in case of the RPi Zero.
⬢After the update finishes, you need to log in again.
⬢Congratulations, your updated PrusaLink is ready.

Step 5 OTA PrusaLink Update (in Prusa Connect)

OTA PrusaLink Update (in Prusa Connect)
OTA PrusaLink Update (in Prusa Connect)
OTA PrusaLink Update (in Prusa Connect)
⬢Similarly, you can update PrusaLink from Prusa Connect.
⬢If there are any updates available, the arrow icon shows up on the printer details page. Click the icon.
⬢Confirm updating and wait until the process completes.
This process can take up to a few minutes to finish.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us