1. 組み立てを始める

プリンターメンテナンス

• How to replace the filament sensor (HT90) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools necessary for this chapter
  4. Preparing the printer
  5. Removing the filament sensor
  6. フィラメントセンサー：部品の準備
  7. フィラメントセンサーの取り付け
  8. Connecting & testing the printer
  9. Well done!
• Unpacking the printer (HT90)
• How to install the Camera dummy module (HT90)
• How to replace the door (HT90)
• How to lubricate linear bearing rails (HT90)
• How to replace HEPA filter (HT90)
• How to clean external filters (HT90)
• How to replace the desiccant in the Prusa Pro Filament Drybox
• How to replace a high-temperature nozzle (HT90)
• How to lubricate the magballs (HT90)