1. 組み立てを始める

プリンターメンテナンス

• How to replace Heatbed (CORE One)
• How to replace Heatbed Thermistor (CORE One)
• Buddy3D Camera for CORE One Installation
• How to replace the Prusa Nozzle (CORE One)
• How to reverse the door orientation (CORE One)
• How to pack the Prusa CORE One for return - Original Packing material
• How to install Advanced Filtration (CORE One)
• How to pack the Prusa CORE One for return - Custom Packing material
• How to replace the xBuddy board (CORE One) [進行中の翻訳]
  1. 組み立てを始める
  2. Introduction
  3. Tools necessary for this guide
  4. Important: Electronics protection
  5. Printer Preparation (Part 1)
  6. Printer Preparation (Part 2)
  7. Back Cover Removal (Part 1)
  8. Back Cover Removal (Part 2)
  9. xBuddy Cover Removal
  10. NFC Antenna Cover Removal
  11. Cables Disconnection
  12. Cables Disconnection 2
  13. Cables Disconnection 3
  14. Wi-Fi Cover Removal
  15. Wi-Fi Removal
  16. xBuddy Removal
  17. xBuddy Parts Preparation
  18. Thermal Pad Application
  19. xBuddy Installation
  20. Wi-Fi Installation
  21. Wi-Fi Cover Installation
  22. Power Cables Connection
  23. Zip-Tie Installation
  24. Extension Cable Connection
  25. Power Cables Connection 2
  26. PE Cable Connection
  27. Cables Connection 1
  28. Cables Connection 2
  29. Cables Connection 3
  30. Cables Connection 4
  31. Cables Connection 5
  32. Wiring Check
  33. xBuddy Cover Installation
  34. Rear Cover Installation
  35. Turning the Printer On
• How to replace Nextruder Filament Sensor (CORE One)
• How to replace Heatsink NTC Thermistor (CORE One)
• How to replace Hotend Heatsink (CORE One)
• How to replace the print fan (CORE One)
• How to replace the Heatbed Power Cables (CORE One)
• How to replace a Hotend Thermistor (CORE One)
• How to replace a Hotend Heater (CORE One)
• How to replace a hotend assembly (CORE One)
• How to install the Nextruder V6 Nozzle Adapter (CORE One)
• How to replace the door sensor (CORE One)
• How to replace the side filament sensor (CORE One)